Primers
Q Prime DPMQ/Prime DPM is a two component, solvent free damp proof membrane designed for use as a coating over cementitious surfaces which posses high levels of residual moisture. Additionally, D.P.M. may be employed over cementitious surfaces which have not been protected by an underlying moisture barrier. This practice should only be adopted subject to a survey confirming adequate under-lying ground stability. An effective moisture suppressant membrane for oversealing cementitious surfaces which contain high levels of residual moisture. Permits early overlaying with vinyls, carpets and resin based products without the conventional “drying out” period being observed. Also suitable as an overlay D.P.M. to cementitious surfaces which were laid without underlying D.P.M.
Q Prime TCQ/Prime T.C. is a medium viscosity resin primer/tack coat used for bonding epoxy screed compositions. It has been specifically designed to be tacky to enable trowel applied resin screed to be applied we on wet giving a truly monolithic screed. Q/Prime T.C., resin is absorbed into the resin screed as well as the substrate. Q/Prime T.C. is also used as an adhesive to bond new concrete to old and as an adhesive for polymer modified cementitious flooring. The chemical composition of Q/Prime T.C. permits the resin to cure when in contact with water. Q/Prime T.C. should be used as a primer/tack coat with the following systems:-
Q Prime SFQ/Prime S.F. is a low viscosity solvent free epoxy primer used to seal and prime concrete and other substrates prior to the application of liquid resin systems. Q/Prime S.F. is absorbed into the substrate sealing off surface defects which may cause bubbling on the final surface finish. Q/Prime S.F. is compatible with and adheres to an extensive range of epoxy resin and polyurethane resin flooring systems. Typical Installations:-
|
